ProTXcoat 751 Seal-Tech
Seal-tech
ProTXcoat 751 Seal Tech -ER MEMBRANE- is a single component solvent based acrylic waterproof coating. The product has been designed as an emergency repair material to seal leaking roof and gutter surfaces.
Typical applications
The product is supplied ready to use and is ideal for emergency repairs to roofs, gutters, tank bases and fibreglass structures
TECHNICAL SPECIFICATIONS
Characteristics
| Single Component: | Thixotropic acrylic emulsion | |
| Mixing Ratio | Single Component | |
| Density | 1.35 | |
| Solids content | 70% | |
| Sag Resistance | Nil at 1000 microns | |
| Coverage | ||
| Brush or squeegee applications: The material can be applied in a range of thicknesses dependent on the application. | 1mm WFT | 1m2 per ltr |
| 2mm WFT | 0.5m2 per ltr | |
| Cure Times The applied material should be allowed to harden for the times indicated below before being subjected to the conditions indicated: | ||
| Shower Proof | 10°C | 30 minutes |
| 20°C | 15 minutes | |
| 30°C | 7.5 minutes | |
| Touch Dry | 10°C | 24 hours |
| 20°C | 12 hours | |
| 30°C | 6 hours | |
| Maximum overcoating time | Indefinite | |
| Storage life | 5 years if unopened and stored in normal dry conditions (15- 30°C) |
Mechanical Properties
| Elongation | Tested to ASTM D412 100% |
| Tensile Strength | 42kg/cm2 (600psi) |
| Tested to ASTM D412 | 16kg/cm2 (230psi) |
| Water Vapour Permeability | |
| Tested to ASTM D1653 | 2 x 104 perm.cm |
| Heat Resistance | Resistant to dry heat up to 100°C dependent on load. |
Quality
All ProTXcoat Products are supplied under the scope of the company’s fully documented quality system.
Warranty
ProTXcoat warrants that the performance of the product supplied will conform to the typical descriptions quoted within this specification provided material is stored correctly and used according to the procedures detailed in the Technical Data Sheet for the material.
Health and safety
Please ensure good practice is observed at all times during the mixing and application of this product. Protective gloves and other recommended personal protective equipment must be worn during the mixing and application of this product.
Before mixing and applying the material please ensure you have read and fully understood the detailed Material Safety Data Sheet
Legal Notice
The data contained within this Product Specification is furnished for information only and is believed to be reliable at the time of issue. We cannot assume responsibility for results obtained by others over whose methods we have no control. It is the responsibility of the customer to determine the products suitability for use. ProTXcoat accepts no liability arising out of the use of this information or the product described herein.
